Browse Category: Wedge Clubs


How To Choose The Wedge Clubs Efficiently

It takes for granted that the Wedge club, also known as technical club, is the indispensable item for each golfer. Especially, with the more experienced golfers, the wedge club is an indispensable weapon. To get lots of choices that need to be made when you take up golf and choosing the best golf clubs sets, simply click here for more information.

Learning About The Wedge Club

Speaking in an understandable way, the wedge clubs have the high-aperture surface and are denoted by firms in different ways. Wedge clubs can be denoted by number, showing the openness of the clubs as 52, 56, 58 and can also be denoted by letters: P (Pitching wedge), A (approach wedge), G (gap wedge) , S (sand wedge) or L (lob wedge).

These clubs can be used in many situations, from small chip shots around the green to a simple pitch shots 50-70 yards or sand or some lob situations under bubble up from the thick grass. Due to the fact that the situation on the field is very diverse, the wedge clubs are often specially designed for the golfers to transform as open or close the golf club face, hold shorter or longer wedge clubs. Though the eelection of wedge clubs is not hard, normally it is less concerned by many golfers. Here are some important parameters on the Wedge club that you can pay attention to when choosing.


The loft degree, also called aperture of the club, is one of the most important parameters and is usually written on clubhead. Wedge clubs usually has the aperture from 46 or more than, if indicated by the letter P, it is usually equivalent to 46-48 degrees, A with 50-52 degrees or S with 54-56 degrees. The loft degree is much, then the shaft will be shorter and the ball will fly up and swung more and more.

When choosing a Wedge club set, the loft degree should be spaced 4 to 6 degrees to ensure that the gap will not be too much difference between the clubs. Nor should you choose a loft wedge clubs too large if not necessary because of the fact that more and more loft degree will make it harder in controlling the desired point. If you choose to polish or roll less, 56 or 58 loft degree is usually quite sufficient for any situation, unless you have good technique and really feel the movement of the club while hitting.


Despite not getting much concern as the loft degree, the bounce has huge influence. The Degrees of bounce is the angle keeping plane and the bottom surface and generally clubs ranged from 4 (low) to 14 (high), depending on the loft and the other top designer of the club. If used efficiently and correctly, the appropriate bounce helps golfers to transform in many situations and therefore Wedge club can be promoted using both on sand and on grass.

Normally, the low bounce will suit typing glide across the ground (effective with hard ground) and will suit many of bounce when the club makes some moving toward the ball from the top down (effective for the soft ground) . When used in sand, the low bounce will match hard or wet sand, so the most effective treatment in this case is to get the club to go surfing just below the surface of the sand.

It depends on each person’s technique, but generally when choosing the Wedge clubs, you should pay attention more to bounce to get the bat suit the handling way of the terrain or your yard you often play.


Grind is designed to bottom surface of the technical club and often produced in accordance with the loft and bounce. Grind is especially important if you tend to close or open the bat when hitting. With the bottom surface, which is ground under appropriate grind, you can open the front edge clubs without fear rising too high and would lead to relative horizontal of the ball.

Not only that, with appropriate grind, you can fully control the displacement of the bottom surface of grass or clubs on the surface of the sand, leading to the control surfaces in contact with the ball. When choosing a wedge clubs, you will see different grind designs.